Quick Search
  • Home Page
  • About Us
  • Contact Us
  • Customer Help
Email Special Offers
Monster Delas - FREE Delivery month
Browse by Category
Essentials Range
Browse by Category

Credit Cards Accepted
Special Offers from Shop4 Electrical

IP65 Anti-Corrosive Lighting

A range of single and twin lamp IP65 weather resistant and dustproof luminaires. Ideal for use in adverse weather conditions. Supplied as standard with high frequency control gear for improved energy efficient, flicker free operation and instant start.

Garage forecourts, farm buildings etc.

Body formed from GRP. Acrylic or polycarbonate diffuser. White finish steel gear tray. Durable gasket to seal luminaire. High frequency control gear enables this fitting to operate down to a temperature of -25°C. Complies with EN 60598. Stainless steel clips are supplied with all luminaires fitted with polycarbonate diffusers.


LinearPac™ LED anti-corrosive is an ideal solution for both interior and exterior applications, allowing for an energy reduction compared to traditional linear fluorescent fittings. Popular for car parks, service areas, warehouses or retail applications, LinearPac creates the needed lighting levels while providing the energy savings desired.


The UniPac™ range of anti-corrosives is the perfect cost effective solution to replace traditional T8 fluorescent fittings. Formed from a single polycarbonate body and using high lumen LED chips, it's engineered for installation in the most challenging environments making the decision to switch to LED that much easier


Thorn Aquaforce LED offers a range of IP65 rated LED luminaires for high quality low energy lighting in wet, dusty environments The traditional design gives an aesthetically pleasing appearance – ideal for direct replacement on refurbishment projects


With a tough exterior, Julie is the optimal choice for industrial and commercial applications. High quality, low energy lighting in wet and dusty environments. High quality opal diffuser for uniform lighting. Ideal for replacement and refurbishment projects


Ansell Lighting Tornado LED non-corrosive light fittings allows point-to-point replacement fitting for existing fluorescent luminaires, with a light output that exceeds the performance of traditional T8 and T5 fluorescents. Normally installed in areas that are subject to impact and high humidity.


Ansell Lighting Stormloc LED performance allows point for point replacement of existing fluorescent luminaires. Their light output exceeds performance of T8 fluorescent by up to 37% with up to 48% energy saving compared to T8 fluorescent equivalents.


JCC Lighting ToughLED™ uses advanced LED technology that outperforms fluorescent and extends the life of the product, eliminating maintenance costs and reducing energy usage. ToughLED™ is ideal for commercial, industrial and leisure applications, including car parks, corridors and factories.


These superb fittings replace standard 1 or 2 x 58W. Whilst providing the same mechanical performance as traditional corrosion proof fittings, they will make significant energy savings of around 35% and provide an exceptionally long service life, without the high costs associated with traditional tube changes and labour.


The Lumineux LED weatherproof luminaires are ideally suited to industrial applications where protection from dirt and dust ingress and light impact is essential. Suitable for installation in areas where access is difficult and the cost of maintaining traditional fluorescent sources is high.


A range of single and twin lamp IP65 weather resistant and dustproof luminaires. Ideal for use in adverse weather conditions. Tough polycarbonate body and diffuser with good light distribution and efficiency.


Sylproof Superia is a range of general purpose T8 and T5 water and dust resistant luminaires rated at IP65. Ideal for use in industrial applications, warehouses, storage areas, workfloorsm car parks and covered pathways.


Sealed tough corrosion resistant luminaires for harsh environments. Available in standard and 3 Hour Maintained emergency versions. Grey polycarbonate body with clear diffuser and durable polycarbonate clips. High frequency control gear supplied as standard.